Home › Knowledgebase › KB-1589

Fix Daylight Saving Time Offset On CCTV Recordings

Summary

This guide helps you troubleshoot and resolve: Fix Daylight Saving Time Offset On CCTV Recordings. Follow the steps below to fix the issue.

Quick Tip: Need immediate assistance? 💻 Open a Ticket

Common Causes

Daylight saving time transitions can cause CCTV timestamp overlays to fall out of sync by one hour. An incorrect timestamp can complicate evidence submission, staff roster audits, and compliance records. This guide explains how to check your camera time synchronisation settings, configure NTP sources relevant to Australian time zones, and apply manual offsets where automatic daylight saving adjustment is not available.

Quick Fix Steps

  1. Log into your CCTV recorder or camera management interface.
  2. Navigate to the date and time settings page.
  3. Verify that daylight saving time is enabled and set to the correct Australian schedule.
  4. Check that the NTP server is reachable and configured for an Australian time source.
  5. Save the settings and reboot the recorder if prompted.

Detailed Instructions

1. Access the CCTV Time Settings

  1. Open a web browser on a computer connected to the same network as your CCTV recorder.
  2. Enter the recorder's local IP address into the address bar and sign in with your administrator credentials.
  3. Go to Setup > System > Date & Time or Configuration > System > Time Settings, depending on your device manufacturer.

2. Enable Daylight Saving Time

  1. Locate the Daylight Saving Time or DST option.
  2. Set it to Enabled or On.
  3. Configure the start and end dates to match the Australian daylight saving schedule applicable to your state. Some Australian regions do not observe daylight saving, so ensure your location's schedule is correctly applied.
  4. Click Save or Apply.
If your location operates in a state that observes daylight saving, ensure the DST schedule matches local legislation rather than relying on a generic preset.

3. Configure NTP Time Synchronisation

  1. On the same date and time page, find the NTP or Network Time Protocol section.
  2. Enable NTP synchronisation.
  3. Enter an Australian NTP server address, such as pool.ntp.org or a provider-specific Australian time server.
  4. Set the time zone to match your local Australian time zone (for example, Australia/Brisbane or UTC+10 for Queensland locations).
  5. Select Test or Sync Now to confirm the recorder can reach the time server.
  6. Save the configuration.
If your recorder is on an isolated network without internet access, NTP synchronisation will fail. Use a local NTP server or set the time manually and check it regularly.

4. Apply a Manual Offset on Devices Without Automatic DST

  1. Identify cameras or recorders that do not support automatic daylight saving adjustment.
  2. Open the time settings for each affected device.
  3. Disable automatic DST if it is causing incorrect jumps.
  4. Manually adjust the system clock by one hour when the transition occurs.
  5. Record the change in your maintenance log so future footage remains consistent.

5. Update Firmware

  1. Check the manufacturer's support website for the latest firmware version for your recorder or camera model.
  2. Download the firmware file to a local computer.
  3. Return to the CCTV interface and go to Maintenance > Upgrade or System > Firmware Update.
  4. Upload the file and follow the on-screen prompts to install the update.
  5. After the update completes, reconfirm your time zone and daylight saving settings, as firmware updates can reset them to defaults.

Troubleshooting

Timestamp Is Still One Hour Out

NTP Server Not Reachable

Settings Revert After Reboot

If the timestamp remains incorrect after following these steps, contact your IT support provider for assistance with your CCTV configuration.

Still Having Issues?

Need more help? If the issue persists after trying these steps, please open a support ticket and our team will assist you.

💻 Open a Ticket