SoftDent Imaging Firewall Ports After Security Update
Summary
This guide helps you troubleshoot and resolve: SoftDent Imaging Firewall Ports After Security Update. Follow the steps below to fix the issue.
Common Causes
Following a recent security update to your clinic's perimeter firewall or endpoint protection profile, SoftDent imaging hardware may fail to transmit X-rays and digital scans across the practice network. This typically occurs when the update blocks a non-standard TCP port used by legacy imaging bridges. Restoring imaging connectivity requires identifying the required port range and creating a targeted firewall exception limited to your imaging server and workstation subnet, ensuring your patient management database remains protected from broader internet exposure.
Quick Fix Steps
- Confirm which TCP port your SoftDent imaging bridge requires.
- Identify the IP address range for your imaging server and workstation subnet.
- Create a firewall exception allowing inbound and outbound traffic on that port between those devices only.
- Test image transmission from an imaging workstation to the SoftDent server.
Detailed Instructions
Identify the Required Imaging Port
- Open SoftDent on a workstation that can successfully connect to the imaging server.
- Navigate to Setup > Imaging Configuration.
- Record the TCP port number listed for the imaging bridge or digital capture service.
- If you are unsure, check the SoftDent installation documentation or contact your software vendor for the exact port used by your version.
Identify Your Imaging Subnet
- On the imaging server, open Command Prompt.
- Type
ipconfigand pressEnter. - Note the IPv4 address and subnet mask for the network adapter connected to your clinic LAN.
- Calculate the subnet range (for example,
192.168.10.0/24) so the firewall rule can be restricted to your local imaging devices.
Create the Firewall Exception
- Log in to your perimeter firewall or endpoint security management console with administrator credentials.
- Navigate to the firewall rules, access control, or security policy section.
- Create a new inbound and outbound rule with the following settings:
-
- Protocol: TCP
- Port: The SoftDent imaging port identified earlier
- Source: Your imaging workstation subnet
- Destination: Your imaging server IP address
- Action: Allow
- Save the rule and apply the configuration to the firewall.
- If you use endpoint security software on individual workstations, ensure the same port is allowed through the local firewall profile on those devices.
Verify Connectivity
- From an imaging workstation, launch SoftDent and attempt to capture or import a test image.
- Confirm the image transmits successfully to the SoftDent server without timeout errors.
- If transmission fails, re-check that the firewall rule applies to both inbound and outbound traffic and that no additional endpoint security profile is blocking the port.
Troubleshooting
Images Still Fail to Transmit After Firewall Rule Is Added
- Verify the imaging server and workstation are on the same subnet specified in the firewall rule.
- Check whether a second security layer, such as Windows Defender Firewall or third-party antivirus, is blocking the port locally.
- Restart the SoftDent imaging service after applying the firewall change.
- Review firewall logs for denied packets on the imaging port to confirm the rule is being matched.
Cannot Access Firewall Management Console
- Ensure you are using an administrator account with permissions to modify security policies.
- If your firewall is managed by your IT service provider, request the rule change through your support channel.
If imaging connectivity is not restored after following these steps, Open a Ticket and our team will investigate your firewall and endpoint security configuration.
Still Having Issues?
💻 Open a Ticket