Why Is My Bluetooth Phone Handset Crackling During EFTPOS Transactions?
Summary
This guide helps you troubleshoot and resolve: Why Is My Bluetooth Phone Handset Crackling During EFTPOS Transactions?. Follow the steps below to fix the issue.
Common Causes
If your Bluetooth phone handset crackles or cuts out while your EFTPOS terminal is processing a payment or printing a receipt, you are likely experiencing radio frequency interference. Many EFTPOS terminals and Bluetooth devices operate on the same 2.4 GHz spectrum, which can cause signal degradation during high-activity moments. This guide will help you isolate whether the issue is caused by local hardware interference, WiFi congestion, or a cloud-based VoIP jitter problem.
Quick Fix Steps
Try these immediate actions to see if the crackling stops:
- Move the Bluetooth handset and its charging base at least one metre away from the EFTPOS terminal and its cabling.
- Power cycle the EFTPOS terminal by switching it off, waiting 30 seconds, and switching it back on.
- Restart your Bluetooth handset and re-pair it with the base station.
- Test a call while the EFTPOS terminal is idle, then trigger a test transaction to see if the crackling returns.
Detailed Instructions
Step 1: Isolate RF Interference
Retail environments often have multiple wireless devices competing for airspace. To determine if the EFTPOS terminal is the source of the interference:
- Position the Bluetooth base station away from large metal objects, such as cash drawers or shelving.
- Ensure the Bluetooth handset is not placed directly on top of or beside the EFTPOS terminal.
- If possible, switch the EFTPOS terminal to a wired Ethernet connection instead of using WiFi, reducing the number of 2.4 GHz signals in the immediate area.
- Observe if the crackling occurs only during the "processing" phase or also during receipt printing. If it happens during printing, the thermal printer motor may be causing electromagnetic interference.
Step 2: Check WiFi Channel Congestion
If your shop uses a 2.4 GHz WiFi network, it may be overlapping with your Bluetooth handset and EFTPOS terminal.
- Log into your wireless router's administration panel.
- Navigate to the Wireless Settings page.
- Check which channel your 2.4 GHz network is using. Channels 1, 6, and 11 are the standard non-overlapping channels.
- If your network is on a congested channel, change it to a less crowded option and save the settings.
- If your router supports 5 GHz, connect your business PC and other devices to the 5 GHz band to leave the 2.4 GHz band clearer for your Bluetooth hardware.
Step 3: Analyse VoIP Jitter and Packet Loss
If the audio loss sounds like "dropped words" rather than electrical crackling, the issue may be network jitter rather than RF interference.
- Run a speed test from a computer connected to the same network as your VoIP handset.
- Check for high "jitter" (variation in latency) or packet loss during the test.
- Ensure your router has Quality of Service (QoS) enabled to prioritise VoIP traffic over general web browsing.
- If you suspect a cloud-based issue, check your VoIP provider's status page for any reported outages in your region.
Troubleshooting
Handset continues to crackle after moving the terminal
Try using a different Bluetooth handset if available. If the second handset works without crackling, the original handset may have a faulty Bluetooth radio and should be replaced.
Crackling only happens during EFTPOS printing
This suggests electromagnetic interference from the thermal printer. Shield the EFTPOS terminal cabling or move the printer further away from the communications equipment.
Audio cuts out completely during transactions
This is likely a network saturation issue. Ensure no large downloads or cloud backups are running on the shop's internet connection during peak trading hours.
If you have completed these steps and the issue persists, please contact our support team so we can investigate further.
Still Having Issues?
💻 Open a Ticket